HVAC and Duct Mold Cleaning in Tennessee Colony, TX
Mold in an HVAC system is worse than mold in a room, because the system distributes it everywhere the ducts reach every time it runs.
Evaporator coils are the usual site. They stay wet by design during cooling, and if the condensate pan does not drain properly the standing water feeds growth right where all the air passes. Flex duct with a torn liner and moisture in insulated duct board are the other common findings.
Fleur Mold Remediation inspects and cleans systems across Tennessee Colony, TX: coil cleaning, condensate pan and drain line clearing, HEPA-filtered negative pressure duct cleaning with mechanical agitation, and replacement of duct sections where the liner itself is colonized and cannot be cleaned.
Surface-treating a duct with a fogger is not remediation. If porous liner is affected, that section is replaced.
A smell that appears when the system kicks on and fades when it stops is the diagnostic. That is the system, not the room.
Call Fleur Mold Remediation at (833) 846-0651.
